ECM Manufacture Synchronika, Руководство пользователя

Страница: 36 / 69

Bedienungsanleitung / User Manual/ Handleiding/ Руководство по эксплуатации SYNCHRONIKA
ENGLISH
35
10 CE CONFORMITY
Conformity
The product complies with the following EU Directives:
Machine:
2006/42/EC
Low Voltage: 2006/95/EC
EMC: 2004/108/EC
PED: 97/23/EC
EN-Directives: EN 292-1, EN 292-2, EN 60335-1, EN 60335-2-15 or EN 60335-2-75,
EN 55014, EN 61000-3, EN 61000-4, ENV 50141, EN 55104
11. TROUBLESHOOTING
Problem Possible Cause Troubleshooting
Little or no crema on the top of the
coffee The grind is not fine enough
Use a finer grind.
Tamp the ground coffee more
firmly.
Reduce the brewing pressure.
The coffee is too old. Use fresh coffee
Little or no crema on top of the
coffee
The amount of ground coffee is not
enough.
Use the right coffee amount:
Approx. 7 g
– 9 g of coffee for each
cup.
The shower screen is dirty. Clean the brew group.
Sparse coffee dispensing, only drop
by drop
The grind is too fine.
Set a coarser grind.
Tamp ground coffee only slightly.
Increase the brewing-pressure.
There is too much ground coffee.
Use approx. 7 g – 9 g of coffee for
every cup.
Weak “body”
The grind is not fine enough. Set a finer grind..
The coffee is old. Use fresh coffee.
The amount of ground coffee is not
enough. Use approx. 7 g – 9 g of coffee for
each cup.
The shower screen is dirty. Clean the shower screen.
Foam instead of crema
The beans are improper. Use another type of coffee bean.
The setting of the coffee grinder is
not suited for the coffee beans in
use. Adjust the coffee grinder (When
changing the coffee beans, changing
the grind may also be necessary.)
The machine is switched on, but the
machine does not work.
PID-display is turned off: There is
not enough water in the fresh water
tank
Refill water.
Water has been refilled, PID-display
is off
Switch the machine off and on.
Make sure that the floater in the
water tank is in the correct position.
The side of the floater with the
magnet point must face towards the
inside of the machine. The floater
itself must be inserted with the
magnet point on the upper part of
the floater side.