ECKELMANN AL 300 S, Руководство по эксплуатации

Страница: 8 / 61

Safety instructions
3
Version 3-1 05. Dezember 2019
1 Safety instructions
The safety regulations, codes and notes contained in this section must definitely be observed and
complied with at all times. During repairs on the entire LDS system, the accident prevention regula­
tions and general safety instructions must be observed. Important information (safety instructions
and hazard warnings) are indicated by corresponding symbols (see page 1 of the chapter ”Conven­
tions”).
Follow these instructions in order to prevent accidents and danger to life and limb, as well as dam­
age to the LDS system.
Warning - hazardous electrical voltage!
Danger of electric shock!
Beware of external voltage at the digital inputs and outputs!
All device connections/plugs are only to be plugged in, unplugged and/or wired when off load .
S
This operating instruction is an integral part of the equipment. It must be kept in the proximity of the equip­
ment and must be stored for future use, so that it can be referred to when necessary. To avoid operating er­
rors, the operation instructions must always be kept available for operating and maintenance staff, see Chap­
ter 1.2.
S
For safety reasons, the equipment must not be used for any application other than described in the operating
instruction i.e. only for the intended use, see Chapter 1.3.
S
Before using the equipment, always check that its limits are suitable for the intended application.
S
Check that the electric power supply is correct for the equipment before connecting it to power.
S
When using un-coded plug connectors it is possible to connect them so that there is a danger to life and limb!
If this cannot be excluded, coded plug connectors must be used.
S
Specified ambient conditions (e.g. humidity and temperature limits) must be observed and complied with in
order to avoid malfunctioning (see Section “Specifications”).
S
Check correct wiring of the connections before switching on power to the equipment.
S
Never operate the equipment without its casing. Before opening the casing the equipment must be switched to
zero potential.
S
Note and observe maximum load on relay contacts (see Section “Specifications”).
S
Contact the supplier in any malfunction.
1. According to experience, error message transmission is not yet fully functional during commis­
sioning (no telephone line laid etc.). In such cases, it is strongly recommended to use the available
PRIO1/PRIO2 alarm contacts at the operator terminal to realise the transmission of alarms via a
telephone network.
2. Following the setup of error message transmission, i.e. alarm signalling, it must be tested and in­
spected to ensure correct functioning.
For further information on the CAN bus, see the operating instruction
”Basic and General Safety and Connection Instructions”.