ECKELMANN AL 300 S, Руководство по эксплуатации

Страница: 52 / 61

Alarms and Messages of AL 300
47
Version 3-1 05. Dezember 2019
9 Alarms and Messages of AL 300
No. Messages Cause Correction
Hardware faults
0 internal Fault
nn
The system centre / store computer has per­
formed a restart due to a severe error.
Details can be found in the operating manual of
the system centre or store computer.
Please contact Service Organization
3 RAM Battery Def. RAM battery failure while controller off. Notify Service Organization
4 EEPROM Fault Configuration saving component defect. Replace device
5 EEPROM Contents Configuration data in EEPROM implausible. Please contact Service Organization
8 RTC Fault xxx Real-time clock of E*LDS component xxx
defect. Please contact Service Organization
- Replace device
10 Battery Voltage Real-time clock and RAM backup battery dead. Replace device
CAN bus faults
41 CAN Bus Overflow Communication fault on CAN bus, short circuit
between CAN-LOW (terminal 3) and CAN-HIGH
(terminal 4) Check:
- Wiring of the CAN bus
- CAN bus length (max. 500 m)
- No branch lines
- CAN-GND must be available
everywhere
- CAN bus termination 100 ohms
- Colour scheme complied with
- Correct cable type
(LiYCY 2x2x0,75 mm² with
120 ohms wave impedance)
42 CAN Bus MSGLOST
(= Message lost)
43 CAN Bus Fault
44 CAN Bus Failure
45 CAN Address Conflict Same CAN bus address assigned to two E*LDS
components. Change address of one component
Messages
46 Time Error Real-clock time implausible on restart. -
47 Adjust Time The time in the system centre / in the store
computer has been adjusted. The timestamps
show the time before and after the adjustment. -
48 Adjust Date The date in the system centre / in the store
computer has been adjusted. The timestamps
show the date before and after the adjustment. -