8
Normal Operating Mode -
number of long blinks indicates the linked device type
followed by short blinks counting the number of devices linked.
Description
Learn LED
Power LED
Factory Default
OFF
ON Solid
with linked switch(es)
OFF
1 long blink
followed by short blinks
counting switches repeatedly
with linked occupancy sensor(s)
OFF
2 long blinks
followed by short blinks
counting sensors repeatedly
with linked photo sensor(s)
OFF
3 long blinks
followed by short blinks
counting sensors repeatedly
with central command
OFF
4 long blinks
followed by short blinks
counting sensors repeatedly
Manually Configure Dimming Mode
The dimming mode for the ER6CD-AU-120 Phase Adaptive Dimmer is detected
automatically by default. The dimming mode for the ER6CD-AU-277 is reverse phase by
default. At the device, you can change the dimming mode manually, entering forward
phase, reverse phase, or automatic phase dimming.
1. Simultaneously, press and hold the “Learn” and “Clear” buttons for five seconds,
then release. The CLR/LRN and Status LEDs will begin to flash.
The LEDS indicate which dimming mode is active.
• Both Green: Forward Phase dimming
• Both Red: Reverse Phase dimming
• If the dimmer is in Automatic dimming mode, the Status LED will flash amber, and
the CLR/LRN LED will indicate the current mode with specific LED colors. (red is
Reverse Phase dimming mode and green is Forward Phase dimming mode).
2. To change the current mode, press and hold the “Learn” and “Clear” buttons until
the LEDs change to the desired dimming mode according to the LEDs state.
Note: The device will return to normal operation, exiting the dimming mode menu, 10
seconds after the last interaction.
Configuring the Controller
There are a few methods of configuring parameters in the controller. Simple Tap is a quick
method of changing a parameters setting, one at a time. For accessing the complete set
of configuration parameters, use the Smart Click process on the following pages.
There are three methods of configuring parameters in the controller.
1. Simple Tap
2. Smart Click
3. Garibaldi Commissioning Software (not covered in this guide)
Simple Tap Instructions
Simple Tap uses the switches and sensors that are linked to the controller to set the
associated configuration parameters. You must be able to access the sensors teach
button and switches to perform the Simple Tap process.
If the sensor is linked to multiple controllers and you do not want to make changes to all,
turn the controllers relay off (lights off) to ignore the Simple Tap changes.
Simple Tap allows you to:
• Enable or disable the motion sensor Auto-ON feature