Support:
Support.Eccotemp.com
Shop Online:
www.Eccotemp.com
Store Locator:
Eccotemp.com/locator
EnglishEnglish
3
9
PLEASE NOTE: SH22 IS FOR OUTDOOR PERMANENT INSTALLATIONS ONLY AND SH22I IS FOR INDOOR PERMANENT INSTALLATIONS ONLY. THIS MANUAL
AND ALL ECCOTEMP CONTENT IS SUBJECT TO CHANGE WITHOUT NOTICE. PLEASE VISIT SUPPORT.ECCOTEMP.COM FOR MORE INFORMATION.
Designed in
Summerville, SC
Support:
Support.Eccotemp.com
Shop Online:
www.Eccotemp.com
Phone:
866-356-1992
WARNING: If you do not follow these instructions exactly, a fire or
explosion may result causing property damage, personal injury or loss of life.
FOR YOUR SAFETY BEFORE USING THE WATER HEATER
OPERATING INSTRUCTIONS
TO TURN OFF GAS TO WATER HEATER
A. This water heater does not have a pilot. It is equipped with an ignition device which automatically
lights the burner. Do not try to light the burner by hand.
B.
BEFORE OPERATING
smell all around the water heater area for gas. Be sure to smell next to the
floor because some gas is heavier than air and will settle on the floor. Test all connections with
a commercial leak detector or soapy water.
WHAT TO DO IF YOU SMELL GAS
•
DO NOT
try to light any appliance •
DO NOT
touch any electric switch;
DO NOT
use any
phone in your building. • Immediately call your gas supplier from a neighbor’s phone. Follow
the gas supplier’s instructions. • If you cannot reach your gas supplier or fire department. •
DO
NOT
return to your home until authorized by the gas supplier or fire department.
C. Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not
push in or turn by hand, don’t try to repair it, call a qualified service technician. Force or
attempted repair may result in a fire or explosion.
D.
DO NOT
use this water heater if any part has been under water. Immediately call a qualified
service technician to inspect the water heater and to replace any part of the control system and any
gas control which has been under water.
1.
STOP!
Read the safety information above on this label.
2. Turn off all electric power to the water heater.
3. Set the thermostat to lowest setting.
4.
DO NOT
attempt to light the burner by hand.
5. Turn the Gas shut off Valve located on the outside of the
unit clockwise to the
“OFF”
position.
6. Wait five (5) minutes to clear out any gas. If you smell gas,
STOP!
Follow
“B”
in the safety
information above on this label. If you don’t smell gas, go to the next step.
7. Turn the gas shut off valve located on outside of the unit counterclockwise to the
“ON”
position.
8. Turn on all electric power to the water heater.
9. Set thermostat to desired setting.
10. If the water heater will not operate, follow the instructions “To Turn Off Gas To Water
Heater” and call your service technician or gas supplier.
1. Turn off all electric power to the water heater if service is to be performed.
2. Turn the gas shut off valve located on the outside of the unit clockwise to the
“OFF”
position.
WARNING: If you do not follow these instructions exactly, a fire or
explosion may result causing property damage, personal injury or loss of life.
