Page 2 of 12
Installation & Mounting:
Mounting
Before proceeding with installation, plan all wiring and cable routing. For orientation purposes, the DuoBeam™ was built with the carriage
bolt track running from left to right (not front to back). The mounting location for the lightbar should be chosen such that the lightbar is level
and visibility to approaching traffic is optimized.
Caution:
When drilling into any vehicle surface, make sure that the area is free from any electrical wires, fuel lines, vehicle upholstery, vehicle
support members, etc. that could be damaged.
!
Permanent Mount
1. Insert carriage bolts into track
2. Place spacer over bolts as shown in FIGURE 1.
3. Align bolts with pre-drilled holes in the vehicle’s surface.
4. Place lock washer and nut on bolt and tighten until secure.
Specifications:
Dimensions:
10.3” x 10.3” x 3.3”
Average
Weight:
6
lbs.
Input
Voltage:
10-16
VDC
Nominal Current @ 12.8VDC:
6 LED Module: 0.5 A max.
8 LED Module: 1.0 A max.
9 LED Module: 1.0 A max.
12 LED Module: 1.5 A max.
Flash Rate: See Wiring Section
Temp. Range: -22
°
F to 122
°
F
-30
°
C to 50
°
C
MOUNTING SPACER
5/16-18” x 1 1/2” CARRIAGE BOLT
VEHICLE MOUNTING SURFACE
5/16” SPLIT LOCK WASHER
5/16-18” SS HEX NUT
FIGURE 1
