Page 3 of 12
Magnet Mount
1. Insert carriage bolts into track.
2. Place oversized washers over bolts as shown in FIGURE 2.
3. Attach magnetic base over bolts.
4. Place lock washer and nut on bolt and tighten until secure.
OVERSIZED WASHERS
MAGNETIC BASE
5/16” SPLIT WASHER
5/16-18” SS HEX NUT
5/16-18” x 1 1/2” CARRIAGE BOLT
FIGURE 2
Pylon/Headache Rack Mounting
1. Insert the four (4) 5/16”-18 carriage bolts in the channels on the under side of the light bar and loosely attach the mounting brackets.
2. Place the lightbar on the vehicle and slide the mounting brackets into position.
3. Secure the brackets to the lightbar with the supplied washers and nuts as shown in FIGURE 3.
4. With the mounting brackets positioned, mark the locations of the mounting hole centers on the roof of the vehicle. Remove the bar and
drill the mounting holes as marked.
5. Secure the mounting brackets to the vehicle with customer supplied hardware.
1/2” BOLT AND MOUNTING
HARDWARE SUPPLIED BY
CUSTOMER
MOUNTING SURFACE
5/16-18 NUT
OVERSIZED FLAT WASHER
BRACKET
5/16-18 CARRIAGE BOLT
LIGHTBAR
FIGURE 3
