Eaton XMCSPAN-001, Инструкция по установке и эксплуатации

Страница: 23 / 48

6. Slide the module port connector into the slot opening on the XMCspan front panel.
7. Align the module over the XMCspan.
8. Align the connectors on the underside of the module with the corresponding connectors on the XMCspan.
Connectors Mezzanine Card Slot
When installing a PMC/PrPMC module, use the following connectors: J11, J12, J13,
and J14.
When installing an XMC module, use J15.
Mezzanine Card Slot 1
When installing a PMC/PrPMC module, use the following connectors: J21, J22, J23,
and J24.
When installing an XMC module, use J25.
Mezzanine Card Slot 2
9. Align the keying hole on the module with the keying pin on the XMCspan.
10. Gently press the module onto the XMCspan.
11. Turn the XMCspan component-side down.
12. Insert the four short Phillips screws supplied with the XMCspan through the holes on the underside of the
module, into the standoffs at the corners of the base board, and then tighten the screws.
Note: Some PMCs use a screw at each corner; others require only two screws at the forward corners.
6806800H03A | XMCspan Installation and Use |
23
Hardware Preparation and Installation