Eaton XMCSPAN-001, Инструкция по установке и эксплуатации

Страница: 20 / 48

Non-Operating Operating Requirement
- - Forced Air Flow
5% to 95% non-condensing at +40°C
(+104°F)
5% to 95% non-condensing at +40°C
(+104°F)
Relative Humidity
-300m to 13000m -300m to 3,000m Altitude
5-20 Hz at 0.01 g
2
/Hz 0.1g from 5 to 100 Hz and back to 5 Hz at a
rate of 0.1 octave/minute
Vibration
20-200 Hz at -3.0 dB/octave
Random 5-20 Hz at 1 m
2
/Sec
3
Random 20-200 Hz at -3 m/Sec
2
Half-sine, 15g/11ms Half-sine, 5g/11ms Shock
1,200 mm/all edges and corners (pack-
aged)
100 mm/3 axis Free Fall
POWER REQUIREMENTS
The XMCspan uses only +5.0 V from the VMEbus backplane. On-board power supplies generate the required
voltages for the various ICs. The XMCspan connects the +12 V and -12 V supplies from the backplane to the
PMC sites while the +3.3 V power supplied to the PMC sites comes from the +5.0 V backplane power. A maximum
of 15A of +3.3 V power is available to the PMC sites, however the 90 W +5.0 V limit must be observed as well
as any cooling limitations.
The following table provides an estimate of the typical and maximum power required.
Notes Measured Power Board Variant
1.5 A at 5 V 7.5 W XMCspan
2.6 A at 5 V 13 W XMCspan with 2x MEN P601
7.6 A at 5 V 38 W XMCspan with 2x PMC Test Adapter
7.9 A at 5 V 39.5 W XMCspan with 2x PrPMC-280S
The following table shows the power available when the XMCspan is installed in either a 3-row or 5-row chassis
and when PMCs are present.
20
| XMCspan Installation and Use | 6806800H03A
Hardware Preparation and Installation