Figure 12.
Configure Adapter Settings
Figure 13.
Set ConnectUPS Adapter IP Address
Figure 14.
Save and Exit
Figure 15.
ConnectUPS Adapter Summary Page
EATON
Powerware
®
ConnectUPS
t
Web/SNMP Adapter (E Model) Quick Start Instructions 164950186 Rev A
9
Section 4
Configure the Adapter
To configure the adapter after you have connected it:
1.
Type
1
on the Main Menu to display the Web/SNMP Adapter
Settings screen (see Figure 12).
2.
Type
1
to display the Set the IP Address, Gateway Address
and MIB System Group screen (see Figure 13).
3.
To set the IP Address, type
1
and press
Enter
. Type the IP
Address and press
Enter
(see the Checklist).
4.
Type
0
to return to the previous menu.
5.
Repeat Steps 3 and 4 to set the Gateway Address and
Network Mask.
6.
Change any other options as needed for your particular
configuration by typing the corresponding number shown in
the menu.
Each Configuration Menu setting is described in detail in the
Appendix of the
ConnectUPS Web/SNMP Card User’s Guide
.
You can change the other options later if you prefer.
7.
Type
0
until you return to the Main Menu (see Figure 14).
8.
Type
0
to save all settings and exit the adapter configuration.
9.
Verify network communication by using a Web browser (see
Figure 15). Type the IP Address of your adapter and select
Go
. The ConnectUPS Adapter summary page opens.
NOTE
Once the adapter is reachable on the network, you
can use a Web browser, Telnet, or similar utility to adjust any
of the configuration settings. The menus are identical to
those seen during serial configuration and are
password-protected for Superuser access only.
