Eaton Powerware 9305 UPS, Быстрый старт

Страница: 7 / 12

Figure 9. Select Connection
Figure 10. Configure Port Settings
EATON Powerware
®
ConnectUPS
t
Web/SNMP Adapter (E Model) Quick Start Instructions 164950186 Rev A 7
Section 3
Connect the Adapter
NOTE If you used the serial cable labeled “PC” in the
ConnectUPS-E installation, temporarily remove the cable from
the UPS and adapter. When configuration is complete, plug the
serial cable back into the UPS (X101/male port) and the
ConnectUPS-E UPS port.
To connect the adapter to the computer and start the
configuration:
1. Plug the RJ-45 end of the supplied serial cable (labeled “PC”)
into the PC port on the adapter.
Verify that you have used the port labeled “PC.” The other
port on the adapter will not work for configuration.
2.
Plug the other end of the serial cable into the serial COM port
on the computer.
3. Open your terminal emulation program (such as HyperTerminal).
4. Select the appropriate serial connection (such as COM1). See
Figure 9.
5.
Set the serial line to 9600 baud, No parity, 8 data bits, 1 stop
bit, and no flow control (see Figure 10).
6.
Verify that the UPS is turned on.