Eaton PDI WaveStar, Руководство по установке и эксплуатации

Страница: 33 / 68

Eaton PDI WaveStar Color Monitor Setup and Operation Manual P-164001109—Rev 01 23
55..22..22 EEnnhhaanncceedd S Suubbffeeeeddss S Seettttiinnggss
BCMS Enhanced Subfeeds (ESF) devices are for large PDU subfeeds to other PDUs and RPPs. A single ESF
Points List can monitor 1-14 subfeeds (see
Figure 18 ):
• If CTs on installed on ABC-phases only, 14 subfeeds can be monitored.
• If CTs are also installed on neutrals (ABCN), at most 10 subfeeds can be monitored.
Figure 18. Settings: Enhanced Subfeeds (ESF)
Touch fields to change parameters:
NAME : Enter a unique device name (up to 16 characters);
device name is propagated to header and device list.
START
: Number for first ESF Circuit Breakers, touch to
increment.
# OF CBS
for this ESF: Touch to increment; can be from
1-14 subfeed circuit breakers if phases ABC have CTs;
can be 1-10 if ABCN have CTs.
BCMS notifies Color Monitor if neutrals have CTs.
Touch to set VERSION number for ESF board software.
The new
VERSION
number appears in the
SOFTWARE
VERSIONS list.
55..22..33 B BC CM MS S N Noorrm maall aanndd K KW WH H S Seettttiinnggss
BCMS panelboard devices — BCMS KWH and BCMS (Normal) — have the same settings. BCMS KW and
BCMS KWH are default names used in different software versions for the same points list, shown in Figure 19 .
You can set the device NAME and software VERSION with the pop-up keyboards. You may have to enter a
password first.
You can sequentially number panelboard circuits for up to eight (8) 42-circuit panelboards, allowing
measurement and alarm identification for all 336 circuits in an 8-panelboard PDU.
Standard panelboards are always laid out 1, 3, 5… 41 down the left side and 2, 4, 6… 42 down the right side.
Select ODD/EVEN to display them in this order or select STANDARD to display them as consecutive numbers
(1, 2, 3... 42) down left then down right side.
Device Chain: Settings