14
OnGuard Command Console
Installation Manual
ONGUARD COMMAND CONSOLE INSTALLATION MANUAL
www.eaton.com/onguard
E x 42 Large Console
E x 36 Medium Console
E x 34 Small Console
I x 6
F x 2
8� For three piece worksurfaces ensure that the splines
and tie bolts engage into their respective slots and holes
in the center worksurface� Thread a T nut onto each tie
bolt� Ensure that the worksurfaces are properly aligned
with each other, then tighten the tie bolts to draw the
worksurfaces together�
9� Check to see if the bottom of the worksurface assembly
sits flush against ALL of the worksurface support frames�
If not, re-level the base cabinets as required to bring the
components into alignment�
NOTICE
DO NOT TWIST OR FORCE THE WORKSURFACE INTO ALIGN-
MENT WITH THE SUPPORT STRUCTURE. THIS CAN BUILD
STRESS INTO THE SYSTEM AND AFFECT THE LIFTING ACTION.
10� Attach the worksurface to the support structure with
¾" Phillips head wood screws�
11� Attach the control pad to the worksurface with (2) #8 x
½" Phillips head wood screws� Retain the cable in the
adjacent slot with the plastic clip supplied (clip is not
required on small one piece worksurfaces)�
12� Lift the free ends of the cable chains up through the
openings in the base cabinets� Attach the cable chains
to the previously installed channels with (4) #10 x
5
⁄
8
"
Phillip’s flat head self-threading screws, and(4) #10 lock
nuts (2) per cable chain�
K x 2
J x 4
SECTION III - Assembling the Console
Hardware required
Hardware required
Hardware required
E�11
E�12
E�10