12
ONGUARD COMMAND CONSOLE INSTALLATION MANUAL
www.eaton.com/onguard
OnGuard Command Console
Installation Manual
E. Install the Worksurface
WARNING
UNPLUG THE POWER CORD FROM THE AC OUTLET BEFORE
PROCEEDING.
Medium and large console worksurfaces are comprised of
three pieces that must be fastened together� The small size
console worksurface is a single piece�
1� Carefully unpack the worksurface(s) leaving the protective
foam edges in place� Place the worksurface down on a
protective surface�
2� Both notched and un-notched plastic trim strips are
provided� Insert the (2) notched trim strips onto the edges
of the rectangular opening in the center worksurface� The
flexible tabs on the trim strips should be flush with the
decorative writing surface of the worksurface�
3� Insert the (2) un-notched trim strips onto the edges of the
rectangular slots in the left and right worksurfaces� The
flexible tabs on the trim strips should be flush with the
decorative writing surface of the worksurface�
4� Assemble (1) monitor pole sliding bracket and (1) channel
to the bottom of each outer worksurface as shown, using
(4) ¾" Phillip’s head wood screws for each channel� The
studs in the anchor plate will protrude through the flexible
plastic trim strips�
SECTION III - Assembling the Console
E x 8
Decorative
Writing
Surface
Flexible Tab
Vertical Flange
This Side
Hardware required
E�2
E�3
E�4