Operating instructions ResistTel IP4/IP162
03/22
64
7
Warnings and safety instructions
This equipment is a weatherproof Voice-over-IP phone, especially for operation in harsh industrial en-
vironments.
The following warnings and safety instructions must be observed:
The telephone is designed in protection class II and may only be connected and operated at the
prescribed voltages.
The connection and installation of the device must be carried out by trained personnel in accordance
with the prescribed installation regulations.
Care must be taken to ensure proper connection. The connection cables must be laid in such a way
that there is no risk of tripping.
It is important to make sure that the phone, the connection line, etc. are not damaged. In the
damaged state, operating the phone is not allowed.
If no cable is plugged into the side connection socket, the cover cap necessary for the tightness of
the housing must be plugged into the side connection beech.
The telephone may only be operated under the specified environmental conditions (see Chapter 6
Specifications on page 62). Adverse environmental conditions, such as ambient temperatures.B that
are too high or too low, are not permitted because this promotes the failure of electronic compo-
nents.
The telephone may only be operated under the specified electrical conditions (see Chapter 6 Spec-
ifications on page 62). In particular, the warnings stored there must be observed. Failure to comply
with electrical conditions and warnings can lead to property damage and personal injury!
When operating the telephone, the legal and commercial regulations, accident prevention regula-
tions, as well as electrical regulations must be observed.
In the case of repairs, only original spare parts are permitted, which must be changed professionally.
Other replacement parts may cause damage and the warranty is void.
Before repairing or replacing the phone, it must be disconnected from all power sources. If mainte-
nance or repair under voltage is unavoidable, this may only be done by qualified personnel.
When the phone is open, no dust must enter the device.
Repair work may only be carried out by the manufacturer himself, or by a person commissioned by
the manufacturer, when a new piece test is carried out, for the device. This also applies to the
replacement of the cable ends installed by the manufacturer, depending on the type and design of
the telephone.
For repairs, only original spare parts are permitted. Other replacement parts can cause property
damage.
The operation of this device or device can cause radio interference in the living area.
Changes to the product that serve technical progress are also possible without prior notice.
FHF Funke + Huster Fernsig GmbH
Gewerbeallee 15 - 19 • D-45478 Mülheim an der Ruhr • Web: http://www.fhf.de
Phone: +49 – 208 - 8268-0 • Fax: +49 – 208 - 8268-286 • Mail: [email protected]
Orders: [email protected] • Requests: [email protected]
Support: [email protected]
