Operating instructions ResistTel IP4/IP162
03/22
22
1
Destination no.
F1
-
5011
Off
2
Key not assigned
-
-
-
-
...
9
Key not assigned
-
-
-
-
3.6
Relay-Onboard, Relay-1 and Relay-2
outputs
The control of the relay-onboard, relay-1 and relay-2 outputs is configurable to signal selected states of
the phone via connected external equipment, such as for example the ringing of the telephone via an
optical signaling device. In the factory setting, all three outputs are preset to "
Alert on
" and are thus
switched on when the phone signals (rings) an upcoming call. In the web interface
WepIp162\Device\Re-
lays\Relay-Xyz
, select the tab for the relay and select the
Working Mode
drop-down list to define the
desired control for the relay in question. Depending on the selected control, the exact working method
can be specified by means of further dialog elements.
3.7
Inputs Input1-Input3
Configurable functions
can
be triggered
via
the Input1 – Input3 inputs, such as for example the dialling
of a destination number or the control of the headset conversation mode. In the factory
setting, all
three inputs are preset to "disabled" and thus without effect.
In the
WebIp162\Device\Keypad
web
interface, select the
Input1
–
Input3
drop-down lists
to define the desired mode of operation of the
respective input. Select "
Headset, press
" to use the input to control the headset conversation mode or
one of the "
Function key, xxx
" modes to recreate function keys with the input. In the latter case
,
the
function
key dialogs must be edited in the main menu
Main menu\User list
\
n UserName
\
Function
key\f FctKeyNo\
in order to set the desired behavior of those function keys, which you have selected
in the web interface for the input (see also 3.5
Function keys Shift 0-Shift 9 on page 21).
The table below shows the results of a configuration in which all three inputs trigger the dialing of a
destination number when a connected key is pressed.
Input
f-FctKeyNo
Type:
Text:
Icon:
Number:
Prepare:
Input1
11
Destination no.
F11
-
5111
Off
12
Key not assigned
-
-
-
-
Input2
13
Destination no.
F13
-
5113
Off
14
Key not assigned
-
-
-
-
Input3
15
Destination no.
F15
-
5115
Off
16
Key not assigned
-
-
-
-
3.8
Test of dialling method "immediate dialling"
In the operation of the telephone, two manual dialling methods of immediate dialling and dialling prep-
aration are used, the former being not supported by all PBXs. If your PBX does not support the instant
dial dialling procedure, in which every digit entered is immediately transferred to the PBX, a remedy can
be found in the web interface. So first test whether there is a need for action. To do this, pick up the
handset and enter a multi-digit phone number. If the dial fails after entering the first digit with an error
message "unknown number", the configuration parameter
Enbloc Dialing Timeout [s]
of the register
card
WebIp162\Phone\User-1\General\
must be set from the factory-set value 0 to e.g., 2. The set
timeout of 2 s causes the phone to wait 2 s after each digit input whether further digits follow. Not until
2 s after the last entered digit, the collected digits are then transferred to the PBX.
