Page 41
Chapter 6: Detectors/Devices Menu
This chapter explains the options in the Detector/Device menu.
Detectors
Add/Del Detectors
This option allows you to add and delete radio detectors (zones).
Adding radio detectors
To add a radio detector:
1.
Select
Panel
(if applicable) or a radio expander to assign that detector to.
2.
Select a zone.
A “*” to the left of a zone name indicates that the control unit has learned a radio
detector for that zone.
3.
When prompted, activate the detector's tamper switch to make the control unit learn
the identity of the radio detector.
Deleting radio detectors
To delete a single radio detector, select the zone and choose one of the following:
Delete Detector ID
This deletes the ID of the detector, but leaves any zone configuration in place (such
as zone type and attributes).
Default zone
This deletes the ID of the detector and sets all the zone configuration to default
values.
Note:
The deletion takes place immediately, and not when you leave the Installer menu.
When you delete a radio detector, the control unit sets the zone to Not Used, and deletes
the identity of the radio detector that it has learned.
Up to three levels of
Delete all
options are provided (see the menu map on page 31).
These allow you to delete all radio zones associated with a selected expander, all radio
zones that communicate directly with the panel (if applicable), or all radio zones system-
wide.
Program Zones
You can program (configure) each zone's behaviour at any time, whether or not a wired
detector is connected, or the control unit has learned the identity of a radio detector. Select
the zone you wish to program. Please refer to page 26 for details of the zone numbering
scheme.
Note:
If a wired zone does not have a detector connected to it, make sure that its zone
type is Not Used (the default).