Eaton Cooper Power Systems RLY-800, Инструктивный листок

Страница: 11 / 14

Eaton’s Cooper Power Systems
11
CT-Y0-0556
!
SAFETY
FOR LIFE
Installing an External Remote Antenna
An external remote antenna can be connected to the
RLY-800 with a coaxial cable though the Type-N RF
Bulkhead External Antenna Connector. This
connector is shown in
Figure 3 on page 5 .
Perform the following steps to install and connect an
external remote antenna to the RLY-800:
1. Identify the installation location for the mast
pole and external remote antenna on the utility
pole.
2. Mark the location for the all-thread rods that will
attach the mast pole to the utility pole.
3. Drill two holes through the utility pole for
installing the 5/8 inch all-thread rods.
4. Install the mast pole onto the all-thread rods.
5. Secure the all-thread rods to the utility pole and
mast pole with 5/8 inch washers and nuts.
6. Attach the external remote antenna to the mast
pole with two mounting brackets.
7. Install washers and nuts to secure the external
remote antenna and bracket to the mast pole.
8. Attach a lightening arrestor to the external
remote antenna.
9. Install a copper grounding rod at the base of the
utility pole below the lightening arrestor.
10.Route a 10 AWG ground wire between the
lightening arrestor and the copper grounding
rod and secure with ground wire staples.
11.Attach the ground wire to the lightening
arrestor that was installed on the antenna.
12.Attach the ground wire to the copper
grounding rod with a ground rod clamp.
13.Route a 400 series N-Connect Male to N-
Connect Male antenna cable between the
lightening arrestor and the RLY-800.
14.Connect the antenna cable to the remote
external antenna.
15.Connect the antenna cable to the RLY-800
external antenna connector.
16.Secure the antenna cable to the utility pole with
antenna cable clamps.
The external remote antenna installation is
completed. You are ready to supply power to the
RLY-800 as described in
“Wiring the RLY-800” on
page 12 or “Wiring the RLY-800 to a Street Light
Sensor” on page 12 .
Figure 14. External Remote Antenna Installation
External
Remote
Antenna
Mounting
Bracket
Lightening
Arrestor
Mast Pole
5/8 Inch All
Thread
Washers
and Nuts
Copper Ground Rod
10 AWG Ground Wire
Ground Rod Clamp
400 Series N-Connect
Male to N-Connect Male
Antenna Cable
Ground Wire Staple
Antenna Cable Clamp
Utility Pole
Up