Eaton CEAG CG-Controller, Руководство по эксплуатации

Страница: 19 / 36

19 Manual CEAG CG-Controller for CG 2000/ZB-S 30080001458 (C) July 2016 www.ceag.de
9 Menus
9 .7 .3 Luminaire status (device type=CG2000)
During communication with the system, «Please wait...» is displayed.
If there is an error, the faulty communication process is automatically
repeated. The read process then lasts somewhat longer. Directly after
a functiontest it takes 100s until all datas are on the LON-bus.
Line
Selection (status display)
1
Device status *
2
Failure reports *
3
Circuit-status *
4
Luminaire-status
∕
5
DLS/TLS/3PHW-status *
6
Charging-/bat.stat.*
Line
Selection / display:
1
Circuit
XX ↔
2
...5...10...15...20
3
  
-------
4
Name
Operation:
Menu One menu level higher

/

Selection in Line
1: Next/previous circuit
3: Next/previous luminaire
(if luminaire overview mode
is activated; i.e. if the cursor
is in Line 2)

Selection: Luminaire name

Selection: Luminaire
overview
Line 2 shows luminaire numbers
from 1 to 20
Line 3 shows luminaire informa-
tion:
 – – – – – – – – – – – – –
– – –
Meanings of the icons:

lum. is turned off
 lum. is turned on
lum. is defective
no lum. present
(not programmed in the luminaire
setup)
Name = current name if the
cursor is in Line1.
Name = luminaire name if
the cursor is in Line 2. An
arrow points to the selected
luminaire.
For additional information on the
content of Lines 2 and 3: See the
info box below.
9 .7 .4 Luminaire status (device type=ZB-S)
During communication with the system, «Please wait...» is displayed.
If there is an error, the faulty communication process is automatically
repeated. The read process then lasts somewhat longer.
Line
Selection / display:
1
Circuit
XX ↔
2
...5...10...15...20
3
Luminaire information
4
Name
Operation:
Menu One menu level higher
 /  Selection in Line
1: Next/previous circuit
3: Next/previous luminaire
(if luminaire overview mode
is activated; i.e. if the cursor
is in Line 2)
 Selection: Luminaire name

Selection: Luminaire
overview
If no luminaire is present in the
selected circuit, „No luminaire
info“ is displayed.
For additional information on
the content of Lines 2 and 3:
See the info box below.
Line
Display:
1
Read
2
Current assignment
3
4
Please wait...
Operation:
Menu One menu level higher
Line
Selection (status display)
1
Device status *
2
Failure reports *
3
Circuit-status *
4
Luminaire-status
∕
5
DLS/TLS/3PHW-status *
6
Charging-/bat.stat.*