![background image](http://html1.mh-extra.com/html/eaton/ceag-at-s-series/ceag-at-s-series_mounting-and-operating-instructions_3838380066.webp)
66
Appendix
MANUAL CEAG AUtoMAtiC tEst systEM At-s
+
40071860177 (C) December 2016 www.ceag.de
V-CG-SB Monitoring module
with DALI control input
UV-A
Switch-/dimming unit
e.g. day light sensor
external DALI-controller
DA
LI
-B
us
incl. DALI-EVG
incl. DALI-EVG
incl. DALI-EVG
max. 1m!
V-CG-SUW Monitoring module
with change over unit
230V
Requirements for connecting of electronic control
gears in fluorescent lamps or electronic control gears
for LEDs to AT-S
+
systems
ATTENTION!
Care must be taken to ensure that only control gears
with sinusoidal current consumption are used in
combination with the new AT-S+ system . Therefore
all control gears must be complied with „Limit Values
for Devices of Class C“ according to DIN EN 61000-3-2
Point 7 .3 a .) .
Ballasts for discharge lamps with an input power of
≤ 25 W are regulated according to DIN EN 61000-3-2
Point 7 .3 b) . These limit values are not sufficient under
certain conditions . Thus for these devices as well, a
confirmation according to EN 61000-3-2 Point 7 .3 a .) is
mandatory .
Likewise, for all LED control gears a confirmation
according to EN 61000-3-2 Point 7 .3 a .) is also man-
datory although LED drivers in this respect have not
been standardized until now .
Background: In AC operation control gears ≤ 25 W as
well as LED control gears can generate current dis-
tortions . A clear fault detection is not possible and
2 different function tests could generate 2 different
results . Our own control gears of the V…-series are
suitable for AT-S
+
systems independently of the condi-
tions specified above .