![background image](http://html1.mh-extra.com/html/eaton/ceag-at-s-series/ceag-at-s-series_mounting-and-operating-instructions_3838380030.webp)
30
5 Transport, Packaging and Storage
MANUAL CEAG AUtoMAtiC tEst systEM At-s
+
40071860177 (C) December 2016 www.ceag.de
5 Transport, Packaging and Storage
5.1 Safety Notes
WARNING! RISK OF INJURY
There is a risk of injury when transporting or loading
due to falling parts .
ATTENTION!
DAMAGE TO PROPERTY!
The system will be destroyed or damaged by
improper transport .
The following safety notes have to be observed:
•
Never lift loads over person´s head.
•
Always move the system with great care and attention.
•
Only use lifting accessories and hoisting devices with
enough loading capacity.
•
Always handle and store the AT-S+ system upright (see
markings and „do not tilt“ sign on the pack)
•
Avoid ingress of dust and moisture during handling.
•
Ensure that all transport routes
– are clear (sufficient width and headroom for all trans-
port movements),
– provide enough room for persons to take evasive
action if loads tip over or slip,
– have sufficient loadbearing capacity (for the load,
transport packaging and handling equipment)
– could not overstrain the used transport equipment in
regard of increase and constitution of underground.
•
Use only
– handling equipment (e. g. pallet trucks, fork trucks,
etc.)
– slinging equipment (lifting beams, chains, ropes, etc.)
– and securing equipment (chocks, timbers, guide/
tensioning/securing ropes, etc.)
that are in technically perfect condition and of adequate
loadbearing capacity.
•
Follow all information shown on the transport packaging
and/or on the device/control cabinet relating to handling,
transport position, slinging points.
•
The equipment must be handled by persons familiar
with the appropriate procedures and signals and able to
carry out the handling operations properly and with due
regard to safety and hazard procedures.
5.2 Transport inspection
Check delivery on receipt for completeness and for
transport damages, immediately. If external damage is
detected do not accept the delivery, except under protest.
5.3 Packaging
If no return
–
agreement exists for packing material sepa-
rate it according to type and size for further use.
ATTENTION!
DAMAGE TO PROPERTY!
Packing material has to be recycled in an
environmentally friendly way and according to the
local provisions governing disposal . If necessary,
commission special recycling company .
Observe notes for handling printed on the packing material!
5.4 Storage
Keep packages closed up to mounting and observe the
external marked arrangement and storage notes.
Store packages under the following conditions:
•
Not to be stored outside
•
Keep dry and dust-free
•
The storage location should be clean and tidy
•
The time of storage should be as short as possible
(FIFO-method)
•
It is forbidden to stack one pallet/system above the other