![background image](http://html1.mh-extra.com/html/eaton/ceag-at-s-series/ceag-at-s-series_mounting-and-operating-instructions_3838380042.webp)
42
8 Operating
MANUAL CEAG AUtoMAtiC tEst systEM At-s
+
40071860177 (C) December 2016 www.ceag.de
displaying
– Time and date (line 0)
– Operating mode (line 1)
– Fault information (line 2)
– Device name (line 5)
Keypad
ESC key <ESC>
Menu key
ok key <ok>
and cursor keys
Memory card for saving and data
transmission of test log and parameter
settings
Control module
CU S
+
Main screen (Example)
1
Test & status menu
1 .1
Start functiontest
1 .2
Sum failure info
1 .3
Circuit state
1 .4
Luminaire state
1 .5
DLS/TLS/3PhW state
1 .6
Relay state
•
If password protection is activated,
then only the main screen and the
main menu options “1 Test and Status
Menu” and “2 Block ,Reset” are acces-
sible without entering a password.
•
The controller software automatically
returns to the main screen if no entry is
made within 180 seconds.
•
The graphic display backlighting goes
off if no entry is made within 180
seconds.
Pressing any key switches the back-
lighting on again.
•
The contrast and brightness (backlight-
ing of the graphic display) can be
adjusted in the main screen when the
<ok> key is pressed:
<ok> +
/
: contrast adjustment
<ok> +
/
: brightness adjustment
These parameters can also be set with
menu option “3.10 Display Setting” in
menu “3 Basic Settings”.
Here the parameters can be numerically
set as percentages.
Main menu
1 .
Test & status menu
2 .
Block & reset alarms
3 .
Basic settings
4 .
DLS/TLS setup
5 .
Circuit setup
6 .
Luminaire setup
7 .
Logbooksetup
8 .
Send ServicePinMsg
NOTE
Multi-Master Mode M3:
In Multi-Master Mode the follow-
ing functions are possible to
activate:
– Start FT
– Substation-status (display)
– Block/release device
– Date/Time (set)
– Automatic FT (specify)
•
Previously, the substation needs
to be found in the menu «Main
settings /Substation setup».
•
Before the execution of the
command there is a request in
the Mulit Master Mode if this
system-no. or all systems of
one group should execute this
command.
The M3 function can only be
executed when all control units
are interconnected over the CG-S
bus and no CGVision is used.