45
8 Operating
MANUAL CEAG AUtoMAtiC tEst systEM At-s
+
40071860177 (C) December 2016 www.ceag.de
Overview:
Main menu
Test & status menu
Block & reset alarms
Basic settings
DLS/TLS Setup
Circuit setup
Luminaire setup
Logbooksetup
Menu 1
Start functiontest
Sum failure info
Circuit state
Luminaire state
DLS/TLS/3PhW state
Relay state
Selection of
menu options
with the keys
<ok>:
confirm selec-
tion
<Menu>: can-
cel and return to
the previous
menu (any
changes
entered are
saved)
<ESC>: cancel
and return to
the previous
menu (any
changes en-
tered are not
saved)
flashing input
prompt
Line selection (line 1 / 3) with
Select a relay in line 1 with
Line 4 shows the current relay status
Select between “dropped out” and
“picked up” in line 3 (e.g. for test pur-
poses) with
Relay:
1
Status:
switched
<ok>
Menu 1.6:
Note:
See also menu option 3.7 “Relay assign-
ments” in menu 3 “Basic settings”.
<ok>
Menu 1.5:
DLS module external
2
1 2 3 4 5 6 7 8
DLS/TLS Text
TLS module external
3
1 2
DLS/TLS Text
Submenu 1.5 depends on the device
(DLS/3PhW or TLS) that is being addressed
by the selection in the menu.
Select an address with
Line 2/3 shows the current status of
the signal outputs of the external mod-
ule or a current fault message. Line 4
shows the device name (see “4 DLS/
TLS Setup”).
Note:A 3-phase monitor status (L1...L3)
is shown when the external DLS/3PhW
module has been configu-red as a
combined DLS/3-phase monitor.
Switch status/Phase Off
Switch status/Phase On
DLS+3Phase monit.
1
1 2 3 4 5 L1 L2 L3
DLS/TLS Text
Start functiontest
Sum failure info
Circuit state
Luminaire state
DLS/TLS/3PhW state
Relay state
Start functiontest
Sum failure info
Circuit state
Luminaire state
DLS/TLS/3PhW state
Relay state
