To order parts and supplies: 800.343.9353 >> eastwood.com
15
MILL MAINTENANCE
For maximum performance, maximum operating safety and long life, it is critical that the Mill be properly maintained.
BEFORE EACH USE:
1.
Fully inspect the Mill for any damage. Any damage should be repaired before use.
2.
Any damage or scratches to machined surfaces should be worked out with a good quality Oil Stone.
3.
WITH UNIT UNPLUGGED and POWER OFF, operate all manual Handwheels, Cranks and Levers by hand to make sure they all operate smoothly and
accurately.
4.
If any operating features are found to be loose or out of adjustment, follow the adjustment procedures outlined in the appropriate section of this manual.
5.
Add a few drops of a good quality, medium bodied machine oil to all sliding, rotating and pivoting points.
AFTER EACH USE:
1.
Carefully remove all swarf and metal chips from the Mill.
2.
If coolant has been used, make sure it is all removed from the Mill
3.
All components must be dry. All machined surfaces should be coated with a light
bodied machine oil to prevent surface rust.
4.
Remove all cutting tools or drills, cover machine and store in a dry, temperature
stabilized location.
MOTOR BRUSH REPLACEMENT (NOT INCLUDED):
1.
The Motor Brush Retainer Caps are located at the upper end of the Motor Housing
(FIG 26)
.
2.
Remove by unthreading the Caps and pulling out the Brushes from their bores.
3.
Replace the Brushes into the bores using extreme care not to chip them or
damage the springs.
4.
Replace the Retainer Caps.
FIG. 26
✓
