10
Eastwood Technical Assistance: 800.343.9353 >> [email protected]
THE MILL TABLE “14”
• The Mill Table
“14”
is moveable in two axis: The X Axes which is side to side
and the Y Axis which is forward and back. In addition, by tilting the angle of the
Column up to 45° in either direction, the Table is angularly adjustable in relation
to the cutting tools.
• The X Axis movement is controlled by the Table Travel Handwheel
“15”
located
at the right side of the Table. Rotating it Clockwise moves the Table to the Left
by exactly 0.625” per revolution, while rotating the Handwheel Counterclockwise
moves it Right by exactly 0.625” per revolution
(FIG 11)
.
• The Y Axis movement is controlled by the Cross-Feed Handwheel
“16”
located
at the front of the Table. Rotating it Clockwise moves the Table Inward by exactly
0.625” per revolution, while rotating the Handwheel Counterclockwise moves it
Outward by exactly 0.625” per revolution
(FIG 12)
.
• A Table Pointer and Scale
“19”
at the Front of the Table
(FIG 13)
indicates the
rough dimensional location of the X Axis while a precise Pointer and Radial Gauge
marked in 0.001” intervals are integral with the stem of the Handwheel
(FIG 14)
.
Note that the Radial Gauge can be rotated to allow for indexing.
NOTE:
Refer to
“Backlash Compensation” section of this Manual.
• A Pointer and Radial Gauge is built into the base of the Table Travel Handwheel
“16”
marked in 0.001” intervals, indicates the precise dimensional location of the
Y Axis
(FIG 11)
. Note that the Radial Gauge can be rotated to allow for indexing.
NOTE:
Refer to “Backlash Compensation” section of this Manual.
FIG. 11
FIG. 12
FIG. 13
FIG. 14
