20
Form E-564
Eastman
®
7. Remove Socket Head Screw from top of
the Crank. Hold the Crank Shaft by inserting a
pin in the bottom of the Crank Shaft to prevent
spinning.
NOTE: Rotate the Crank Shaft by hand to access
the pin hole if necessary.
8.
From bottom, remove (2) Socket Head
Screws and Lock Washers to remove the
Bushing Clamp.
9.
Push up from the bottom and pull the
Reciprocating Knife assembly out from
the top.
10.
Completely remove the Reciprocating
Knife Assembly from the tool head.
11. Place on a flat surface to continue to
replace the Crank Bearings and the Ball
Joint Assembly .
Hex Head
Screw
Wedge
Washer
Crank
Clamp
Crank
Shaft
Insert Pin
Here
Socket Head
Screw
&
Lock Washer
Bushing
Clamp
Reciprocating Knife
Assembly
Bearings
Ball Joint
Assembly
Reciprocating Knife Assembly contains sharp
knife. Handle with care. Failure to do so may
result in serious personal injury.
WARNING
CAUTION
Handle Reciprocating Knife Assembly with care.
Excessive force may cause damage.
NOTE: Loctite pin used during Installation.