©
EAE Technology
www.eaetechnology.com
Page 18 / 21
Product Manual MD
100
EAE KNX Presence Detector
MD
100
PM R
1.0
Used brightness
*internal
external
This parameter determines that brightness val
internal or external.
ue which is used for constant light con trol will be
Maximal variation from set point value
15 lux
*30 lux
45 lux
60 lux
This parameter is used to adjust hysteresis value for set point value. (-30…set point value…+30)
Dimming level is only sent by “dimming level” object if current brightness value is out of the range
specified with maximal variation of set point value.
Max step size for dimming
0.5%
1%
1.5%
2%
2.5%
3%
*5%
This parameter is used to select step size dimming for constant light control. “Dimming level” object
sends the dimming values (1 byte) with selected step size to reach the appropriate brightness in the
room for set point value. (%100, %95, % 90 etc.)
Transmit next dimming value after
0.5s
*1s
2s
3s
5s
This parameter is used to specify the time interval between two sending dimming value. After
sending a dimming value (%60), next dimming value (%55) will be sent after the time interval
selected.
Finish constant light level control with
*only dimming value telegram
switching off
This parameter defines the way in which constant light level control will end.
Only dimming value telegram: If there is sufficient ambient light in a room, constant light level
control is ended by only dimming value telegram.
Switching off: If there is sufficient ambient light in a room, constant light level control is ended by
switch (OFF) telegram.
Lighting group X offset to dimming level
for group 1
-100…
*0
…100
This parameter is used to express offset value of additional Lighting Group X (X: 2, 3, and 4) according
to “Lighting Group 1”. An offset parameter will be created for every additional lighting group.
Lighting level control
*disable constant light and dim
don’t disable and no action
