©
EAE Technology
www.eaetechnology.com
Page 14 / 21
Product Manual MD
100
EAE KNX Presence Detector
MD
100
PM R
1.0
3.4
Presence
Presence Parameters
Blue LED
*show movement
off
If “show movement” is selected, blue LED inside the detector lights up with movement detection.
Presence switch ‘ON’ delay [sec]
*0
…5
Parameter defines presence detection switch-on time (in seconds). After a detection, sensor waits
until “Switch ON delay time” is expired and sends the presence information to “Presence output”
with a secondary detection.
Min. number of movements detected
during switch ‘ON’ delay
*1
…20
“Presence switch ON delay” is started after detecting first movement. Detector waits for selected
number of movements during “Presence switch ON delay” time in order to send that the presence
information is “ON”.
Presence stay ‘ON’ time [sec]
1…
*10
…255
This parameter defines lighting stay-on time (in seconds). Detector sends “on” telegram via presence
output object at detected movement and stays “ON” until the adjusted time runs out.
Break in presence detection[sec]
*0
…255
Movements detected are ignored during the period selected. This parameter is used to avoid
incorrect detections if temperature changes after lights switched “OFF”.
Switch ‘ON’ delay and stay ‘ON’ time can
be changed by bus
*no
yes
If parameter is selected “yes”, “Switch ON delay time” and “Lighting stay ON time” communication
objects will be visible.
Send presence cyclically
*inactive
15s
30s
1 min
5 min
