EN
Removing the Control Surfaces
To remove the control surfaces, follow the steps
listed below:
Elevator
1. Disconnect the clevis from the control horn.
2. Remove the machine screws located on the
bottom of the horizontal stabilizer. Then remove
the horizontal stabilizer from the fuselage.
3. Remove the screw located on the hinge line at the
root of the horizontal stabilizer.
4. Carefully separate the elevator from the horizontal
stabilizer.
Note:
The outer hinge is not open.
Note:
To reinstall the elevator to the horizontal
stabilizer follow the steps listed above in reverse.
Rudder
Reverse the steps located in the “Installing Rudder”
section for rudder removal.
Ailerons
1. Disconnect the ball-link from the control horn.
2. Remove the machine screw located on the bottom
of the wing. Then carefully remove the wing from
the
fuselage.
Note:
You will need to unplug the aileron servo lead
before removing the wing.
3. Remove the two screws located on the hinge line.
One is located at the wing tip and the other at
the
root.
4. Carefully separate the aileron from the wing.
Note:
To reinstall the aileron to the wing, follow the
steps listed above in reverse.
11