EN
Installing Horizontal Tail and
Pushrods on Control Horns
Installing the Horizontal Tail
1. Put the horizontal stabilizer tube in the round hole
located in the horizontal stabilizer slot of the
fuselage.
2. Slide the left horizontal stabilizer onto the
stabilizer
tube.
3. Slide the right horizontal stabilizer onto the
stabilizer
tube.
Note:
Make sure the elevator joiners interlock with
each other, allowing both elevators to move together.
4. Secure each horizontal stabilizer with the included
machine
screws.
Installing Pushrods on Control Horns
CAUTION:
The installation positions of the
pushrods and clevises directly affect aircraft
response. When these are incorrectly connected for
the pilot’s skill level, unexpected aircraft response to
controls can result in unintended crash damage to
the aircraft.
Note:
The elevator and rudder pushrods come with a
nylon clevis already installed and a 90˚ bend
already bent.
Elevator Pushrod Installation
1. Locate the 6 1/2-inch (165mm) pushrod.
2. Carefully spread the clevis and put the clevis pin
into the hole in the control horn.
Tip:
You can thread the clevis in and out to shorten
or lengthen the pushrod. Make sure transmitter trims
and sub-trims are centered before making mechanical
adjustments.
3. Slide the 90° bend into the third hole from
the
screw.
4. Snap the 90° pushrod keeper on the pushrod. This
holds the pushrod to the servo arm.
Rudder Pushrod Installation
1. Locate the 7 7/8-inch (200mm) rudder pushrod.
2. Carefully spread the clevis apart and slide the pin
into the control horn.
3. Slide the 90° bend of the pushrod into
the outermost hole on the servo arm.
4. Snap the 90˚ pushrod keeper on the pushrod. This
holds the pushrod to the servo arm.
Note: Not to scale.
Aileron
Rudder
Elevator
Arms
9
