E-FLITE Byp Yak, Инструкция по сборке

Страница: 22 / 40

Motor and Speed Control Installation
Required Parts
• Airframe • Receiver
• 3mm x 5mm screw (4) • 3mm washer (2)
• Prop adapter • Hook and loop material
• 10-amp electronic speed control
• Propeller (10 x 3.8 recommended)
• Brushless outrunner motor (EFLM1200 recommended)
Required Tools and Adhesives
• Foam-safe CA
• Phillips screwdriver (small)
• Hex wrench, 3/32"
Note : It is very important to check to be sure
the propeller is balanced before installing onto
the shaft.

1. To use an E-flite ™ Outrunner, the shaft of the
motor must exit the fixed part of the motor
instead of through the rotating portion. You will
have to change this. Loosen the setscrew in the
rotating part of the motor. Slide the shaft though
the motor and tighten the setscrew.
Note
: Please follow the instructions included
with your E-flite Outrunner motor for
repositioning of the propeller shaft.
22