E-FLITE Byp Yak, Инструкция по сборке

Страница: 15 / 40

 
11. Slide a .045" x 13" (1.15mm x 330mm)
carbon rod near the wing strut on the bottom
wing to the center of the top wing near the
fuselage. Leave at least 1/16" (1.5mm) of the
rod exposed at both ends. Glue the rod only at
the bottom wing. Apply foam-safe CA to the rod
both at the inside and outside in order to capture
the rod in position.
 
12. Place the bottom wing on a surface that will
allow the wing panel to lie perfectly flat. Apply
glue to the inside edge of the rod. Once the glue
fully cures, carefully lift the airframe and apply
CA to the top of the rod.

13. Repeat Steps 11 and 12 to complete the
cross bracing.
15