E.F. Johnson Company 5100 ES, Руководство по эксплуатации

Страница: 85 / 212

ES Series Models II/III Portable Radio Operating Manual 5-11
Conventional Mode Features
begin speaking as with a standard call. If the channel is changed, operation continues
on the new channel in the emergency mode.
3
With analog calls, subsequent presses of the PTT switch cause the DTMF emergency
ID to be sent according to the ANI programming (if DTMF ANI is enabled on the
channel). With digital calls, the calls continue to have the emergency bit set.
4
If the Surveillance Mode is enabled (see Section 4.10), all indicators, lights, and tones
are disabled. If “No Receive Activity During Emergency” is programmed, receive
audio, the front panel LED, and receive icons are disabled in the receive mode.
5
To exit this mode, cycle radio power or press and hold the Emergency button.
5.9.4 External Emergency Switch
ES Series Portable radio models support the External Emergency feature. A special man-
down switch (currently available only from third-party vendors) can be attached to the
accessory connector of the radio.If this feature is enabled by programming and the radio is
in a horizontal position for longer than the programmed time (0-63 seconds), an
emergency condition is triggered the same as if the Emergency button was pressed. The
emergency can be canceled by a press and release of the Emergency button.
Note Accessories, such as speaker-microphones, cannot be used with this feature.
5.9.5 Emergency Talkgroup
A user may program an Emergency Talkgroup. If Emergency is activated, the radio uses
the Emergency Talkgroup instead of the programmed talkgroup. If Talkgroup Lock is
programmed, the Emergency Talkgroup has priority.
5.10 Conventional Mode Scanning
Channel scanning features common to all operating modes are described in Sections 4.11
and 4.12. The following information describes features unique to conventional operation.