Dynalab Test Systems
NX Tester User’s Guide
19
Copyright 2011
Revised 04/27/2011
TEST PTS RESET
SER 1&2 >CALIBRATE
SER 3&4
SYSLOG
Firmware 2.1.108
Boot 14
Backplane 1.3.11
PLD 1.1
>LEDs
TURN All ON
Test Active Program
Test All LEDs
3/18
3
3
Test All LEDs
3/1024
CALIBRATE
Select CALIBRATE to access the CALIBRATION menu. The functions available on the
CALIBRATION menu are explained in detail in the NX Application Note entitled “Calibration
Verification”.
INFO
The INFO selection causes the NX Tester to display version information
MORE
The MORE selection offers one option: LEDs. This diagnoses fixture mounted LEDs that are controlled
by the Modular Control System’s LED Module. Selecting LEDs will display the following menu:
•
Turn All ON
– this causes all fixture mounted LEDs to be turned on
•
Test Active Program
– if the currently selected program references LEDs in the Fixture Blocks
View, this will cause each fixture block LED to be illuminated one at a time. The Up and Down
arrow buttons can be used to scroll through the list of fixture blocks. The display shows which
fixture block is being viewed in the upper right corner. It also displays the fixture block name
and the LED number:
•
Test All LEDs
– this allows the user to scroll through every LED by using the Up and Down
arrow keys. If the displayed LED is wired to the tester through the MCS Led Module, the tester
will illuminate the LED.
Displaying 3
rd
of 18 fixture blocks
Fixture block name
LED number
Displays the currently selected LED
