dynabook E10-S, Руководство по обслуживанию

Страница: 68 / 133

3 Diagnostic Programs 5. Appendix
Maintenance Manual Satellite Pro E10-S / dynabook E10-S 3-20
This test treats PC’s each HDD/SSD/eMMC as a physical unit, and reads the sectors on the disk to check if the device works
correctly. The test never writes any data on the HDD/SSD/eMMC.
The Test checks up to the first 16 built-in ATA/SATA/SCSI/iSCSI/NVMe/MMC/SD bus type’s HDD/SSD/eMMC.
The test reads a data chunk at a time, which consists of consecutive sectors the size of which equals to 64K bytes. Hereafter, the
data chunk is called “64KB-Sectors”.
Depending on the test mode (Detail or Simple), the test defines “Division number” as follows:
■
In case of Simple mode: Division number = 1000
■
In case of Detail mode: Division number = 5000
The test divides the HDD/SSD/eMMC virtually to “Division counts” of the fragments. Then, it reads 64KB-Sectors in each fragment
of HDD/SSD/eMMC from low LBA (Logical Block Address of HDD/SSD/eMMC) to high. If the test reads the 64KB-Sectors from all
of the fragments successfully, it will get 1 Pass.
This is the one cycle of the test. If you set the pass count more than one, the test runs more than one cycle.
The test reads 64KB-Sectors (it is part of one fragment) at same LBA for each cycle.
2) Test screen
▼
Test address …The LBA (Logical Block Address) of HDD/SSD/eMMC being tested now
▼
Drive information … The drive number currently being tested
▼
Progress status … The test progress by the progress bar
3) Test result
If the test runs successfully with all equipped HDD/SSD/eMMC, it will get a pass count. However, if an error occurs with one of the
HDD/SSD/eMMC
, the test is regarded as an error and it will get an error count.
■
In case of PASS
“OK” is shown in the “Result” field on the “Diagnostics” dialog.
The pass count is shown in the “PASS” field.
■
In case of FAIL
“NG” is shown in the “Result” field on the “Diagnostics” dialog.
The pass and error count are shown in the “pass” and” error” fields respectively.
Highest LBA
Lowest LBA
………
Physical Disk
M = Division number
Fragment1 Fragment M Fragment 2
: 64KB-Sect
Fragment 3
Fragment M-1
Drive information
Test address
Progress status