20
Dymax Edge-Carry Conveyor User Guide
Four 5000-EC Lamp Configuration
▪
Starting with an empty Lamp Cradle, install the four 5000-EC Lamps into the Lamp Cradle.
Figure 37. Empty Lamp Cradle
Figure 38. Four Lamp Configuration
Single 2000-EC or 1200-EC Lamp Configuration
▪
Starting with an empty Lamp Cradle (Figure 39), relocate the Center Divider Plate (Figure 40) and install
the Lamp Spacers as shown in Figure 41.
▪
Install the 2000-EC or 1200-EC Reflector into the Lamp Cradle.
Figure 39. Empty Lamp Cradle
Figure 40. Move Center
Divider Plate
Figure 41. Install Spacers
Dual Fusion Lamp Configuration
▪
Remove any Lamp Cradle Spacers. Relocate the Cradle Center Divider Plate and install the Fusion Lamp
Brackets and the RF Detector Support (Figure 43).
▪
Install the RF Detector, the Fusion Lamps and Power Supplies as described in the Fusion Lamp Setup
Section of this manual. Adjust the speed of the Exhaust Blower by setting the Speed Control Knob as
described in the Conveyor Operation Section of this manual. The Dual-Fusion Conveyor also requires
installation of a Heat Guard on the front surface of the Conveyor.
