16
Dymax Edge-Carry Conveyor User Guide
Figure 19. One Irradiator Mounted
(Close Up)
Figure 20. RF Dectector's Connector Cord
6.
Connect the Irradiator Cable(s) to the Irradiators (Figure 21 & Figure 22).
Figure 21. Connect Irradiator Cables to
Irradiator(1)
Figure 22. Connect Irradiator Cables to
Irradiators (2)
7.
Unpack the Power Supply(ies) (Figure 23). A 220-Volt Power Cord is provided with each Power Supply.
The Power Supplies may be configured for either 50 Hz or 60 Hz operation and for 208-, 220-, 230-, or
240-Volt operation. Changing between 50 and 60 Hz operation requires repositioning of two Capacitor
Jumpers in each Power Supply. The Power Supply’s shipping box is labeled with the voltage and frequency
set at the factory. Detailed Power Supply setup instructions are provided in the Fusion Lamp technical
manual.
Figure 23. Power Supplies
8.
Position the Power Supply(ies) on the c
onveyor’s Mounting Stand or in a location near the
conveyor if the
Mounting Stand was not purchased.
9.
Attach the Connector Cable leading from the RF Detector to the J-105A Receptacle on the back of the
Master Power Supply.
