INTEGRATED LOCKING DOVETAIL FEATURE
The Ultralite frame comes equipped with an integrated locking dovetail. There is a horizontal
locking screw located on the bottom right side of the Ultralite frame. It can be accessed with
a 1⁄8” Allen wrench through a hole in the grip panel. To unlock the UL Airport attached to the
dovetail of the frame, turn the locking screw counterclockwise one full turn and slide the part off
the rail. To attach a part to the rail, slide the part on and turn the locking screw clockwise until
the part is firmly locked in place. If you choose to use a drop forward or other kind of airport
mounting system there are standard 10-32 mounting screw holes located on the bottom of the UL
frame. There is no reason to disassemble the dovetail locking system if you choose not to use it.
NOTE: Be sure that the frame and trigger assembly are kept clean. If there is excess dirt or
paint build up around the trigger, the trigger will no longer move freely. In addition, paint and
dirt can cause the microswitch to not function properly or fail.
NOTE: Be sure you do not pinch the wires between the frame and the body when reattaching
the frame and body.
NOTE: The frame screws should not be overly difficult to screw into the body. If strong
resistance is felt, stop, back the screw all the way out, and try again to avoid stripping either
the threads or the head of the screw.
ULTRALITE FRAME
REMOVING THE ULTRALITE FRAME FROM THE NT11
If there is ever a need to remove the Ultralite frame from the NT11 make sure to follow
these steps.
• Unhook and open the right side of the tool-less grip to expose the circuit board.
• Disconnect the solenoid wire and the eye wire from their sockets by Gently pulling them out.
• Using a 3/32” Allen wrench, turn the front frame screw counterclockwise 2 full turns.
• Finally, using a 3/32” Allen wrench turn the rear frame screw completely out, by turning it
counterclockwise. The frame can now be removed from the NT11.
INSTALLING THE ULTRALITE FRAME ON THE NT11
To reinstall the Ultralite grip frame on the NT11 make sure to follow these steps.
• Make sure the solenoid and eye wires are secured to the under side of the body by the two
orange retaining clips. Route the eye wires under both clips. Route the solenoid wire over the
top of the solenoid and under only the rear-retaining clip. This will help ensure the wires do not
get pinched between the body and frame, and feed smoothly into the frame.
• Feed the eye and solenoid wires through the grip frame, and slide the gripframe into place. It
may be necessary to slide the front frame screw into the frame if it has fallen out during
frame removal.
• Push the back of the frame onto the body taking care not to pinch either the eye or solenoid
wires between the gripframe and the body.
• Use a 3/32” Allen
wrench to screw in the
rear frame screw by
turning it clockwise.
• Use a 3/32” Allen
wrench tighten the from
frame screw by turning
it clockwise.
ULTRALITE FRAME
W W W . D Y E P A I N T B A L L . C O M
W W W . D Y E P A I N T B A L L . C O M
26
27
Содержание NT11
Страница 1: ... ...
