DVS SpycerBox Ultra, Руководство по оборудованию

Страница: 52 / 72

5-12
SpycerBox Ultra Hardware Guide
y
Next close the casing of the system as described in section “Closing
the Casing” on page 5-7.
With the last step finished you have successfully replaced the defective
RAID controller. Now, you have to integrate the new controller in the
existing configuration:
y
Turn on the system as described in section “Starting the System” on
page 4-1.
After the initial booting you will see something like the following on the
screen:
y
Press [Enter] on the keyboard to accept the configuration detected
by the system:
After this the newly installed RAID controller automatically initiates a
verify of the connected hard disks which may take some time. When
finished, the system will continue its booting procedure until the oper-
ating system is fully loaded. You may then continue your work with the
system.
Following foreign Arrays are found:
Array#<x>-RAID-<y>
Press <Enter> to accept the current configuration
Press <CTRL-A> to enter RAID Configuration Utility
Press <CTRL-H> to Pause Configuration Messages
(Default is not to accept if no valid key pressed in 30
seconds)
<Enter> pressed: The current configuration is accepted