DVS SpycerBox Ultra, Руководство по оборудованию

Страница: 46 / 72

5-6
SpycerBox Ultra Hardware Guide
After that the hard disk is replaced and the disk carrier with the new disk
has to be reassembled in the system.
Step 3: Reassembling the Hard Disk
After replacing the hard disk, the disk carrier with the new disk has to
be reassembled in the system. For this perform the following:
y
Slide the disk carrier back into its shaft at the disk array.
y
Push the disk carrier completely back into the shaft by applying
pressure to the disk carrier directly (i.e. do not use the lever to push
the carrier). Move it until you feel the resistance of the hard disk
interface inside the system and until the lever retracts by itself from
the pushing.
y
Then simply close the lever until it snaps back in place which as a
result will slide the carrier completely back in.
With this the replacement of the hard disk is finished. After several min-
utes the replaced hard disk will be automatically recognized by the sys-
tem. Then the rebuild of the data will be initiated on its own. When the
system has finished the rebuild, the DVS system will be fully operational
again.
The shafts of the system disk array (rear) are equipped with
guide rails. See to it that the disk carrier is inserted correctly
into the guide rails before pushing it in.
It is important that you do not use the lever to insert the
disk carrier. Apply an even pressure only to the carrier di-
rectly until the lever moves back by itself.
The disk carrier of the replaced disk should be level with the
others of the array.
During a rebuild real-time processes may not be possible. It is
recommended to restrict accesses to the hard disk array until
the rebuild is finished.
A rebuild takes several hours. It is strongly recommended to
avoid accesses to the disk array during this time, otherwise it
may take considerably longer.