DVS SpycerBox Ultra, Руководство по оборудованию

Страница: 49 / 72

5-9
2
1
3
5
4
Maintenance
I
A
With the casing of the system open, you can now test the fans. For this
you have to plug in the power supply again.
y
Reconnect the power cords.
y
Press the power switch to turn on the system.
y
Observe the fans and memorize the failed one (the fan not revolv-
ing is the broken one).
y
Press the power switch until the system turns off.
y
After this disconnect the power cables once again.
With the broken fan identified you can replace it. For this perform the
following:
y
Press the latch of the respective fan module towards the front of
the system (1).
y
With the locking mechanism released pull the fan module up and
out of the system (2).
Figure 5-4: Removal of fan module
Testing the fans is possible only with an opened casing
and the power turned back on.
Once the power cables are plugged in again do not touch
anything else than the external power cords or the power
switch at the front of the system. Under no circumstances
reach inside the system.
After testing the fans switch off the power and disconnect
the power cables immediately.
1
2
SpycerBox Ultra