Maintenance
Opening and Closing the Casing
5-8
SpycerBox Ultra/Flex | Hardware Guide | Version 3.1
Rohde & Schwarz DVS GmbH
5.2 Opening and Closing the Casing
Some tasks described in this manual require an opening of the sys-
tem’s casing and the closing of it afterwards once the intended work is
finished. Both tasks will be explained in this section.
5.2.1 Opening the Casing
To open the casing of the R&S DVS system perform the following:
1.
Shut down the system as described in section “Shutting Down
the System” on page 4-5.
2.
Disconnect all power cords from the system.
3.
Press the two buttons at the top of the system (1 in the figure
below) and move the cover towards the rear of the system (2 in
the figure below).
Figure 5-3: Removal of the cover of the casing
Once the cover is slid backward, it can be taken off the system.
Safety danger
The system you are working on operates with voltages that
can be hazardous to your health.
Never work on the system or access its interior with
the power cable(s) being plugged in. Make sure the
power supply is disconnected from the components
you intend to work on.
The system must be operated only with the chassis’ cover installed to
ensure proper cooling.
Содержание SpycerBox Flex
