DVS SpycerBox Flex, Руководство по оборудованию

Страница: 53 / 84

5-7 SpycerBox Ultra/Flex | Hardware Guide | Version 3.1
Rohde & Schwarz DVS GmbH
Maintenance
 Hard Disk Maintenance
Step 3: Reassembling the Hard Disk
After replacing the hard disk, the disk carrier with the new disk has to
be reassembled in the system. For this perform the following:
1.
Slide the disk carrier back into its shaft at the disk array.
2. Push the disk carrier completely back into the shaft by applying
pressure to the disk carrier directly (i.e. do not use the lever to
push the carrier). Move it until you feel the resistance of the hard
disk interface inside the system and until the lever retracts by
itself from the pushing.
3.
Then simply close the lever until it snaps back in place which as a
result will slide the carrier completely back in.
Once the faceplate of the R&S DVS system is back in place, the replace-
ment of the hard disk is finished. After several minutes the replaced
hard disk will be automatically recognized by the system. Then the re-
build of the data will be initiated on its own. When the system has fin-
ished the rebuild, the R&S DVS system will be fully operational again.
Lever damage
When using the lever to push the carrier, it might be damaged.
It is important that you do not use the lever to insert the disk
carrier. Apply an even pressure only to the carrier directly
until the lever moves back by itself.
The disk carrier of the replaced disk should be level with the others of
the array.
Rebuild disturbances
A rebuild takes several hours. During a rebuild the performance of
the system will be affected and real-time processes may not be
possible.
Rebuild time depends on the load of the system. It is recom-
mended to avoid accesses or to at least to restrict accesses
to the disk array during this time, otherwise it may take con-
siderably longer.