Dustbane 19352-C-AGM, Руководство по эксплуатации

Страница: 14 / 21

12
At the end of work:
1. release the brush lever;
2. press the detergent button (LED off );
3. press the brush button (LED off );
4. lift the squeegee lever to raise the squeegee from the floor to prevent the continuous pressure from
warping the blades;
5. press the suction button (LED on) and brush lever to start suction. Allow the suction to run for 2
minutes, then release the brush lever and press the suction button (LED off ) to turn the motor off;
6. turn the machine off by pressing the button for at least 4 seconds;
7. remove the brush (or drive disk) to prevent it from warping permanently;
8. depending on the model, unplug from the mains socket or disconnect the batteries
9. empty and clean the recovery tank.
6.8. Some useful tips to get the most from your automatic scrubber
In the event of particularly stubborn dirt on the floor, washing and drying can be performed in two separate
operations.
6.8.1. Prewashing with brushes or pads
1. press the main switch (LED on);
2. press the brush button (LED on);
3. press the suction button (LED off ) to turn suction off;
4. operate the brush lever to enable brush rotation;
5. make sure the suction motor is off and the squeegee is raised;
6. begin washing.
7. adjust the flow of solution to the brush by means of the solution tap (ref. 2).
Flow speed must be regulated according to the operator’s chosen advance speed.
The slower the machine moves forwards, the less water is needed.
Persist when washing particularly dirty points to give the detergent time to perform its chemical action
detaching and suspending the dirt and the brushes time to exert an effective mechanical action.