❏
10. Install the four “AA” batteries into the receiver battery
holder as shown. It may be necessary to loosen the radio plate
slightly to fit the receiver battery in. Make sure to re-tighten the
radio plate screws once the receiver battery is installed.
❏
11. Thread the ball stud into the correct steering servo horn
(included) for your steering servo as shown. Test fit the servo
horn onto your servo first to make sure it is the correct one.
❏
12. Thread the two ball ends onto the steel rod. There
should be 19mm or 3/4" between the two ball ends.
❏
13. Snap one end of the rod onto the steering servo horn.
Snap the other end onto the steering arm. Turn the
transmitter on and center the steering trims. Install the
steering servo horn onto the steering servo as shown. Then
turn the transmitter and receiver off.
❏
14. Install the rod connector into the hole farthest away
from the center on the short servo horn (included). Note:
This hole is slightly enlarged. Place the small metal
washer and 2mm nut onto the bottom of the rod connector.
Make sure not to over-tighten the nut. The rod connector
must swivel freely. Apply a small amount of thread lock onto
the nut to prevent it from falling off during running.
❏
15. Locate the small rod with a z-bend at one end. Install
the z-bend end of the rod into the lower hole of the throttle
arm on the carburetor. Turn the transmitter on again and
Rod Connector
Rod Connector
8
