❏
1. Install the air filter onto the carburetor. Using
the included tie-strap, secure the air filter to the carburetor. Cut
off any excess portion of the tie-strap to avoid interference.
❏
2. Remove the twist-tie from around the receiver antenna
wire. Run the length of the antenna wire through your fingers
to help straighten the wire out. This will make it easier to get
the wire through the antenna tube. Slide the antenna wire
through the antenna tube. Press the antenna tube into the
antenna mount molded into the top of the radio plate.
❏
3. Frequently, there will be leftover wire protruding from
the antenna tube. Do not cut or coil the antenna! Cut two
pieces of fuel tubing 1/8" long and slide them over the
outside of the antenna tube and wire. This is to help hold the
excess antenna onto the tube and avoid getting the antenna
wire cut in a roll over. Note the placement of the fuel tubing
on the antenna tube.
❏
4. It may be necessary to loosen the radio plate to remove
the receiver battery holder. Install 4 "AA" batteries (included)
into the receiver battery holder in the configuration molded
into the battery holder. Install the receiver battery back into
the receiver battery holder as shown. Make sure to re-tighten
the radio plate screws once the receiver battery is in place.
RADIO SET-UP
AIR FILTER INSTALLATION
4
FINISHING THE STREET FORCE GP2 TOURING CAR RTR VERSION (DTXD52**)
