❏
1. Install the “AA” batteries in the transmitter and the
receiver holders.
❏
2. Extend the transmitter antenna.
❏
3. Connect the steering servo, throttle servo and receiver
battery to the receiver.
❏
4. Extend the receiver antenna.
❏
5. Adjust the servo trims of the transmitter to the
neutral position.
❏
6. Switch on the transmitter.
❏
7. Switch on the receiver.
❏
8. Operate the steering and throttle control. Make sure
the servo arms move in proportion to the movement of the
steering wheel and throttle trigger.
❏
9. Switch off the receiver, then the transmitter.
❏
1. Remove the radio plate from the chassis by removing
the 9 screws as indicated in the above photos.
❏
2. Install the on/off switch into the slot in front of the fuel
tank. Remove the face plate from the switch, then install the
switch up through the bottom of the radio plate, and then
install the face plate onto the top of the radio plate. Re-install
the two screws through the face plate and into the switch to
secure it to the radio plate. Be careful to put the switch plate
on correctly with respect to on and off switch positions.
❏
3. Install the throttle/brake servo into the slot next to the
fuel tank. Place the two servo mount blocks onto the bottom
of the radio plate. Then install the four 3x10mm self-tapping
screws through the servo into the servo mounts. Route the
servo wire through the slotted hole between the servo and
the receiver battery holder.
RADIO SET-UP
PREPARING THE RADIO SYSTEM
6
ASSEMBLY OF THE STREET FORCE GP2 TOURING CAR PRE-BUILT VERSION (DTXC0052)
