64
When Messages Appear
When Messages Appear
Message
Status and Solution
Status : When the perforation unit is installed or you select the JOB
that uses the perforation unit, you press the START key or
the TEST key.
Solution : Check if the option unit is correctly installed and then press
the STOP key or the TEST key to restart processing.
Status : When
Apply shrinkage
is set to ON, the trail crease position
is out of speci
fi
cation.
Solution : Set
Apply shrinkage
to OFF or change the trail crease
position.
Status : When
Apply shrinkage
is set to ON, the lead crease
position is out of speci
fi
cation.
Solution : Set
Apply shrinkage
to OFF or change the lead crease
position.
Status : When
Apply shrinkage
is set to ON, the trail cut position is
out of speci
fi
cation.
Solution : Set
Apply shrinkage
to OFF or change the trail cut position.
Status : When
Apply shrinkage
is set to ON, the lead cut position is
out of speci
fi
cation.
Solution : Set
Apply shrinkage
to OFF or change the lead cut
position.
Status : Cards are imposed at improper positions (within 67.0 mm
from the trail edge of the document).
Solution : Program a JOB so that cards smaller than 67.0 mm are not
imposed within 67 mm from the trail edge of the document.
(
→
P.28 Limit of Trail Cutting)
Status : The
fi
nished product exceeds max
fi
nished size.
Solution : Program a JOB (set margin slit positions) so that the
fi
nished
width is within the speci
fi
cations.
(
→
P.27 Limit of Slit)
Status : Error occurred in the DC-616.
Solution : Turn off the power and then turn on again after a few
seconds.
If the same message appears, contact our service person.
Cannot
fi
nish
card within 67mm
from trail edge.
SET>NEXT BACK
Exceeding max
fi
nished size
Set margin slit
positions.
E** - - - error
Check position
of options
to start
Trail crease length
becomes invalid.
All adjust and
shrinkage is
cleared.
Lead crease length
becomes invalid.
All adjust and
shrinkage is
cleared.
Trail cut length
becomes invalid.
All adjust and
shrinkage is
cleared.
Lead cut length
becomes invalid.
All adjust and
shrinkage is
cleared.
Содержание DC-6 Mini
