Duplo DC-6 Mini, Инструкция по эксплуатации

Страница: 41 / 100

2
25
Before Preparing Document
Before Using This Machine
1
No check digit
By adding barcode which indicates JOB number on each document, the DC-616 automatically
sets up the machine and starts the job. Operator can press the START key and leave.
Even if multiple types of jobs are loaded on the feed tray at one time, the DC-616 recognizes
barcode on documents also with the built-in CCD scanner and automatically switches setup and
fi nishes the jobs.
To use this function, each document must have barcode printed on them. Please refer to the
following instructions for speci
fi cations and position of barcode.
1. Speci fi cations
Barcode type : CODE-39
Start and Stop code : Required
Minimum resolving power : 0.254 mm
Thin bar : Thick bar
: 1 : 2.5
Bar height : 4 mm or more
CODE-39 barcode must be used.
Use barcode generator function equipped on your software application or use barcode
generator software.
Positioning the barcode
IMPORTANT
REFERENCE
Barcode may not be read even it is within the speci fi cations depending on
the print quality of printer and document type. If this is the case, enlarging the
barcode may enable it to be read.
2. Position
Document feed direction : The whole barcode should be within 3 to 20 mm from the lead edge.
Document width direction : The whole barcode should be within 25 to 60 mm from the right
edge. (See below)
is the start code designator for CODE-39. Enter * .
is the tenths digit data of the JOB number.
(Example: When the JOB number is 21, the
data is
2 .)
is the units digit data of the JOB number.
(Example: When the JOB number is 21, the data
is
1 .)
is the check digit. (Corresponding to with or without)
is the stop code of CODE-39. Enter
* .
Document feed direction
Document feed
direction
60 mm or shorter
35 mm 25 mm
3 mm
Barcode
Barcode
position range
20 mm
With check digit
* *
* *
Barcode (Automatic JOB selection)
(Optional on 115V model and 230V Asia model)