Duke X-STREAM WASH, Инструкция по установке и эксплуатации

Страница: 9 / 36

9
Installation and Operation of X-STREAM WASH
B. PRE-SCRAPPING
Wares should be scrapped, NOT SCRUBBED, prior
to loading to remove heavy soils and debris. This will
improve wash results, reduce chemical costs and
reduce the number of water changes needed during
the day.
Use the scrapping sink (if equipped) or scrap the wares
in a separate waste area close to the unit. Do not scrape
wares directly into the wash tank.
Pre-Scrapping
C. LOADING WASH TANK
Pots and Pans
Pots, pans, mixing bowls, etc. can be placed into the
wash tank in any order.
Loading Wash Tank
NOTE: Pots and Pans that are stacked or nested
together during the wash cycle will not be cleaned
properly. Pause the cycle and move them apart from
one another.
Utensils and Silverware
Utensils and silver ware must be placed in a utensil
basket.
If your unit was not supplied with a utensil basket, one
can be ordered from the factory. Contact information
is provided in the Customer Assistance section of this
manual.
To use the utensil basket, simply hang the basket over
the side of the wash tank, place the utensils and silver
ware in the basket, and run a wash cycle.
Hang
Silverware
Basket
Utensil Basket Placement
: To prevent bodily injury never
load knives or other sharp objects into the
machine.
Sheet Pans
Load sheet pans as described below to ensure the
best washing methods.
If your unit was supplied with a sheet pan rack, place the
rack into the wash tank in a vertical position (opening
on top). Load the rack with sheet pans, and then pivot
the rack to a horizontal position.
To load sheet pans without the rack, insert the sheet
pans into the wash tank one at a time with the baking
side up. Place the pans in an alternating crisscross
pattern, so as not to have them nest inside of each other.